This warranty does not cover products that have been modified, refurbished, remanufactured, misused, or tampered with in any way. Table 7-2 Alphabetical printer messages Message Description Action Access denied menus locked An attempt has been made to modify a menu item while the control panel security mechanism is enabled by the printer administrator. Color registration detection unit is dirty. Figure 5-31 illustrates this process. This product contains lead in solder. Hewlett-Packard Company 11311 Chinden Boulevard Boise, Idaho 83714 U.
Replace the lever if it is damaged. This can occur even when the printer is offline. A one below the letter on the display indicated paper is present. However, it does not clear the values in the Service menu such as the serial number and page counts. Installing a new overlay optional Some printer models are shipped without the control panel overlay installed. Replacement is generally the reverse of removal.
Press ® to save the preferred language. Once a custom size is set for a tray, that size will be retained until the switch is moved back to the Standard position. Replace the paper pickup assembly. Laitteen saa avata ja huoltaa ainoastaan sen huoltamiseen koulutettu henkilo. To isolate a problem, you can specify which input tray to use, specify whether to use the duplex path, and specify the number of copies to print.
Adhering to the following guidelines will help ensure proper printing on envelopes and help prevent printer jams: q Do not load more than 20 envelopes into Tray 1. Lift the fuser cover completely, and pull on either of the orange tabs to remove the fuser packing tape and plastic shipping locks. See Table 7-27 on page 279. . Failure to completely disconnect the printer could result in severe injury. These server access are the main resource of our library.
Control panel The formatter sends and receives printer status and command data to and from a control panel board. Printing can continue, but there may be unexpected behavior. This method produces smoother gradients and transitions to non-neutral colors, and it produces the darkest black. Öröm, hogy a kütyü forgatásakor valahonnan egy 3 mm átm, kb 10 mm hosszú acél stift kiesett. This test activates and releases the Tray 1 solenoid and the Tray 2 clutch.
The printer is ready and will continue for the estimated number of pages indicated. Common causes of color variation The following list outlines the major causes of color variations between computers, applications, and output devices. Color misregistration occurs when the individual colors do not print directly on top of one another, causing poor print quality. Four levels of edge control are available: q Maximum is the most aggressive trapping setting. You can also send external print jobs to the printer. This may be a result of abnormal characteristics of the printing environment or of other variables over which Hewlett-Packard has no control for example, extremes in temperature and humidity.
Face-down delivery roller is defective. Table 7-1 6 Image defects Image defect Description More information Light image A very light image is printed. While performing the disable cartridge check, you can navigate the menus and print internal pages as desired from the control panel. For more information in the U. Replace the sensor if it is defective.
Inside general With a dry lint-free cloth, wipe any dust, spilled toner, and paper particles from the paper path area, the registration roller, and the print cartridge cavity. Replacement products may be either new or like-new. Do not use media that has been previously printed on or copied. Full Calibrate lasts for about 3 minutes and 15 seconds. Replace the cartridge if necessary. Sensors detect the presence of paper in each of these trays. In case of toner spills, skin and clothing are best cleaned by removing as much toner as possible with a dry tissue, then washing with cold water.
Hewlett-Packard does not support replacement of components on the printer circuit assembles. Bend the tabs out and down. If it is still dirty after cleaning, or if it is worn or damaged, replace the separation pad. Replace the paper pickup drive assembly. Both positive and negative residual toner returns to the photosensitive drums.